Christmas Kissing Ball with Smoothfoam | The Flamingo Chronicals: Christmas Kissing Ball with Smoothfoam

Christmas Kissing Ball with Smoothfoam

Good morning everyone, I hope you had a Merry Christmas!  It's Anita here today to share a fun Christmas project with you. We always have a kissing ball here at our house, and this year I decided to make one I could use year after year. So I pulled out a Smoothfoam ball and went to work.

3 3/8" Smoothfoam Ball
Paper flowers of varying sizes
Wired Leaves and decorative berries
1" Gold floral pins
Velvet Ribbon
Small stapler
paper piercer or small awl
Wire cutters
Beacon 3-In-1 Adhesive

1. Cut a  length of ribbon and fold in half; staple the open ends together about 1/2" from the ends. Spread the two small end pieces apart and pin to the ball using floral pins.
2. Start by stacking two flowers together. Push a floral pin through the center of the flowers then insert the pin into the ball. Continue adding flowers until the ball is covered.
TIP: Start with larger flowers to fill in the background, then add smaller flowers to cover the gaps.

 3. Make sprays of leaves and decorative berries. To secure, twist the wires together and wrap one of the wires around the others several times, very close together (this should be very close to the last leaf). Use wire cutters to clip the excess wire.
4. Use a paper piercer to poke a hole in the ball near the ribbon (move any flower petals out of the way). Apply glue in the hole and insert the end of the wires. Repeat for a total of 3 sprays, spacing them evenly around the top of the ball.
5. Shape the leaves in a downward direction.

No comments:

Post a Comment